If the Blade SR is your first single-rotor and/or collective-pitch equipped
helicopter model, we suggest that you install the optional Training Gear
Set (EFLH1527) before making your first flight. The training gear helps to
further increase the stability of the model while also providing added support
and cushioning to prevent tip-overs and damage to the model from abrupt
landings.
Installing the training gear takes only a few minutes following these steps.
• Thetraininggearsetincludesfourplasticballs,fourballgrommets,
four training gear rods, four rod end caps, four training gear rod to
landing skid attachments and one training gear rod mounting base.
• Locatethefourtraininggearrodtolandingskidattachments.Snap
the attachments to the landing skids as shown below.
• Afterinstallingallfourattachments,locatethefourtraininggear
rods and rod mounting base. Note that the rod mounting base
has a “coned” shape to it. The “pointed” side of the base will face
upward toward the bottom of the helicopter when properly installed.
The base also has two different angles where the gear rods attach.
It is important to orient the base so that the large angle is facing
forward and backward.
Installing the Optional Training Gear
Comments to this Manuals