Blade BLH8000 Instruction Manual download pdf (Page 4)

Box Contents

• Blade

350 QX2

• 3000mAh 3S 11.1V 20C Li-Po Battery

• 3S DC Li-Po Balancing Charger with 5A AC Power Supply

• Spektrum™ DX4 DSMX

4-Channel Transmitter (RTF)

• 4 AA Batteries (RTF)

• Camera Mount

Charging Warnings

The Battery Charger (EFLC3016) included with your quadcopter has been

designed to safely charge the Li-Po battery.

CAUTION: All instructions and warnings must be followed exactly.

Mishandling of Li-Po batteries can result in a ﬁ re, personal injury and/or

property damage.

• By handling, charging or using the included Li-Po battery, you assume all risks

associated with lithium batteries.

• If at any time the battery begins to balloon or swell, discontinue use imme-

diately. If charging or discharging, discontinue and disconnect. Continuing to

use, charge or discharge a battery that is ballooning or swelling can result in

ﬁ re.

• Always store the battery at room temperature in a dry area for best results.

• Always transport or temporarily store the battery in a temperature range of

40–120º F (5–49° C). Do not store battery or model in a car or direct sunlight.

If stored in a hot car, the battery can be damaged or even catch ﬁ re.

• Always charge batteries away from ﬂ ammable materials.

• Always inspect the battery before charging.

• Always disconnect the battery after charging, and let the charger cool between

charges.

• Always constantly monitor the temperature of the battery pack while charging.

• ONLY USE A CHARGER SPECIFICALLY DESIGNED TO CHARGE LI-PO BATTER-

IES. Failure to charge the battery with a compatible charger may cause a ﬁ re

resulting in personal injury and/or property damage.

• Never discharge Li-Po cells to below 3V under load.

• Never cover warning labels with hook and loop strips.

• Never leave charging batteries unattended.

• Never charge batteries outside recommended levels.

• Never charge damaged batteries.

• Never attempt to dismantle or alter the charger.

• Never allow minors to charge battery packs.

• Never charge batteries in extremely hot or cold places

(recommended between 40–120° F) or (5–49° C) or place in direct sunlight.

Low Voltage Cuto (LVC)

Low voltage cutoff (LVC) protects the Li-Po battery from over-discharge in ﬂ ight

and activates when the battery reaches a preset value. When the battery is

discharged to the cutoff point, the aircraft will display rapidly ﬂ ashing red, green

and blue LEDs to warn you it’s time to land. When you see this LED code, land

immediately to prevent over-discharge and damage to the battery.

When the LVC is activated, you have approximately 2 minutes until the battery is

depleted and can no longer maintain a hover. Repeated ﬂ ying to LVC will damage

the battery.

NOTICE: Crash damage and battery damage are not covered under warranty.

IMPORTANT: Always disconnect and remove the Li-Po battery from the aircraft

after each ﬂ ight. Charge your Li-Po battery to about half capacity before storage.

During storage, make sure the battery charge does not fall below 3V per cell.

A connected battery will result in trickle discharge.

1 2 3 4 5 6 7 8 9 ... 17 18

Comments to this Manuals

No comments

Blade BLH8000 Instruction Manual Page 4

Comments to this Manuals

Related products and manuals for Remote controlled toys Blade BLH8000