Blade mSR RTF Instruction Manual download pdf (Page 12)

Troubleshooting Guide

Problem Possible Cause Solution

Helicopter will not

initialize

Throttle at high position

Reset controls with throttle stick at low-

est position, and throttle trim at center or

lowest setting

On computer radios, switches not in

normal position

Set flight mode to OFF/0 and switch

throttle hold off

Throttle servo reversing improperly

conﬁ gured

Correct servo reversing

Refer to your transmitter manual

Helicopter will not

spool up

Low ﬂ ight battery voltage Completely recharge ﬂ ight battery

Motor power decreases

during flight

Receiver uses default soft Low

Voltage Cutoff (LVC)

Recharge flight battery or replace flight

battery that is no longer performing. Re-

place charger batteries (included charger

only).

Climb out rate is greatly

reduced

Main gear has slipped on the main

shaft.

Push main gear back up into position.

Poor tail authority

Tail boom is cracked Replace tail boom

The tail rotor blade is warped

or bent.

Twist rotor blade back into position

or replace.

LED on receiver ﬂ ashes

rapidly and aircraft will not

respond to transmitter

(during binding).

Aircraft not bound to transmitter Bind transmitter to aircraft receiver

Transmitter too near aircraft during

binding process

Power off transmitter, move transmitter a

larger distance from aircraft, disconnect

and reconnect flight battery to aircraft

and follow binding instructions.

LED on receiver ﬂ ashes

rapidly and aircraft will not

respond to transmitter

(after binding).

Less than a 5-second wait between

first powering on transmitter and

connecting flight battery to aircraft

Leaving transmitter on, disconnect and

reconnect flight battery to aircraft

Aircraft bound to different model

memory (ModelMatch™ radios

only)

Select correct model memory on trans-

mitter and disconnect and reconnect

ﬂ ight battery to aircraft

Flight battery/Transmitter battery

charge is too low

Replace/recharge batteries

Helicopter vibrates or

shakes in ﬂ ight

Damaged rotor blades, spindle or

blade grips

Check main rotor blades and blade grips

for cracks or chips. Replace damaged

parts. Replace bent spindle.

Helicopter spins

counter-clockwise in ﬂ ight

Tail motor failing Replace the tail motor and tail boom

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Comments to this Manuals

No comments

Blade mSR RTF Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Remote controlled toys Blade mSR RTF